6 cnc (menu), 7 ita (menu) – Comtech EF Data DMD-2050E User Manual
Page 130
DMD2050E Universal Satellite Modem
User Interfaces
MN-DMD2050E Revision 2
4–18
4.4.2.6
CNC (menu)
IMPORTANT
When the Carrier-in-Carrier
®
option is installed, these parameters are available.
Enable/Disable
{Enabled, Disabled}
Enable or disable the CnC.
MIN SRCH DELAY
{Minimum Search Delay (ms), 0 to Max}
MAX SRCH DELAY
{Maximum Search Delay (ms), Min to 330ms}
FREQ OFFST RNG
{Range of Frequency Offset (KHz) between the
Interferer and the desired received signal.
(+/- 1Khz to +/- 32Khz)}
4.4.2.7
ITA (menu)
IMPORTANT
When the EBEM Network Specification is selected these parameters are available.
ITA Option
{DISABLED, ENABLED}
Enable or disable the ITA Function.
BPSK 1/2
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
BPSK 2/3
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
BPSK 3/4
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
BPSK 7/8
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
BPSK 19/20
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
QPSK 1/2
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
QPSK 2/3
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
QPSK 3/4
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
QPSK 7/8
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
QPSK 19/20
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
8PSK 1/2
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
8PSK 2/3
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
8PSK 3/4
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
8PSK 7/8
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
8PSK 19/20
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
16APSK 1/2
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
16APSK 2/3
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
16APSK 3/4
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
16APSK 7/8
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
16APSK 19/20
{NOT SELECTED, SELECTED}
Used to select the mod/code rate
ITA MARGIN
0.00 .. 2.00 dBm
Sets the ITA link margin (added to the
default entry in Es/No
ITA HYSTERESIS
0.00 .. 2.00 dBm
Sets the ITA hysteresis used to
overlap the ITA switching point