Comtech EF Data DMD-2050E - Manual (Page 139)

DMD2050E Universal Satellite Modem User Interfaces
MN-DMD2050E Revision 2 4–27
4.4.4.2 VOLTAGES (menu)
VOLTAGES MENU
TEMPERATURE
Displays internal temperature.
+1.5V RX SUPPLY Displays the measured voltage of the 1.5 Volt Rx power bus located inside the modem.
+1.5V TX SUPPLY Displays the measured voltage of the 1.5 Volt Tx power bus located inside the modem.
+3.3V SUPPLY Displays the measured voltage of the +3.3 Volt power bus located inside the modem.
+5V SUPPLY Displays the measured voltage of the +5 Volt power bus located inside the modem.
+12V SUPPLY Displays the measured voltage of the +12 Volt power bus located inside the modem.
+20V SUPPLY Displays the measured voltage of the +20 Volt power bus located inside the modem.
-12V SUPPLY Displays the measured voltage of the -12 Volt power bus located inside the modem.
4.4.4.3 CnC (menu)
IMPORTANT
When the Carrier-in-Carrier
® option is installed, these parameters are available.
CnC DELAY Routine delay (ms)
CnC FREQ OFFST Runtime Frequency Offset (KHz) between interferer and the correct
received signal.
CnC RATIO Power Ratio between interferer and the correct signal in dB.
RX BUFFER LEVEL {0 – 100%} Displays the status of the Doppler Buffer.
RX BUFFER RESET (ENTER) Press ENTER to re-center the Doppler Buffer.
4.4.4.4 ITA (menu)
IMPORTANT
When in EBEM Mode and the ITA option is enabled this menu available.
TX WAVEFORM {UNAVAVILABE, Mod and CR}
See section 4.4.1.9 Displays the current modulation and code rate
operating in the transmitter
RX WAVEFORM {UNAVAVILABE, Mod and CR}
See section 4.4.2.7 Displays the current modulation and code rate
operating in the receiver