Comtech EF Data DMD-2050E User Manual
Page 142
DMD2050E Universal Satellite Modem
User Interfaces
MN-DMD2050E Revision 2
4–30
TCP/IP MENU
BOOTp SERVER
{128 – 257,
default is 206}
Only used if Bootp is selected in Boot Mode. Should be consistent
with the tag expected by the users Bootp Server.
MODEM HOST
The Host Modem for the network.
IP ADDR MASK
{XXX.XXX.XXX.XXX} The IP Address Mask of the local network. The mask is expressed in
a hexadecimal format, and must be a valid TCP/IP Mask. This field
should be set before changes are made to the Modem or Router
Address.
MODEM IP ADDR {XXX.XXX.XXX.XXX} The IP Address of the modem. This address should be consistent for
the mask defined. This address is expressed in hexadecimal format.
Broadcast and loop back addresses will not be allowed. These are
addresses with all subnet bits set to 0’s or 1’s.
SERVER IP ADDR {XXX.XXX.XXX.XXX} The IP Address of the Boot Server and the address of the SNMP Trap
Server when SNMP is active. If a server is used and there is no local
router, this address must be consistent with the modem address. If a
router has been specified, the address is presumed to be reachable
via the router. Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0’s or 1’s.
ROUTER IP ADDR {XXX.XXX.XXX.XXX} The IP Address of the Local Network Router. If a router is present on
the local network, this address must be consistent with the IP Mask
and the subnet of the modem. If no router is present, then the address
should be set to a foreign address. This address is expressed in
hexadecimal format. Broadcast and loop back addresses will not be
allowed. These are addresses with all subnet bits set to 0’s or 1’s.
MODEM EADDR
{001065010000}
Displays the Ethernet address of the device. Set at the factory and is
a unique identifier for the Ethernet physical interface.
ETHER RATE
{10 MBPS/HD}
The data rate for the local Ethernet Interface. 10 Mbps/HD – for 10
Base-T in either half-duplex or full duplex.
IMPORTANT
To change the display for the IP ADDRESS MASK, MODEM IP ADDRESS, SERVER IP
ADDRESS, and ROUTER IP ADDRESS, press all four arrow keys simultaneously.