Comtech EF Data DMD-2050E - Manual (Page 147)

DMD2050E Universal Satellite Modem User Interfaces
MN-DMD2050E Revision 2 4–35
CNC BOARD (menu) Indicates the part number for the CNC Board.
DEBUG MODE {ENABLED, DISABLED}
CNC DEBUG REGS1 Used for factory test only.
CNC DEBUG REGS2 Used for factory test only.
CNC DEBUG REGS3 Used for factory test only.
CNC DEBUG REGS4 Used for factory test only.
SCALE AMPLTD Used for factory test only.
AR THRESH FACTOR Used for factory test only.
PLL LOOP THRESH Used for factory test only.
ACQ CNTR THRESH Used for factory test only.
PLL LOOP GAIN Used for factory test only.
4.4.6.10.2 FEATURES (menu)
5012.2840.2417 {____.____.____} Installs purchased feature upgrades (see Appendix A).
Whether or not the feature has been upgraded, or if the feature requires a
hardware upgrade (contact the Customer Service Department or Sales for
hardware and software upgrades).
4.4.6.10.3 UPGRADE LIST (menu)
UPGRADE LIST MENU
10 MBPS, 20 MBPS, 52 MBPS (The highest option installed hides the lower rates.)
52 MBPS
IBS 16QAM
TURBO 52 MBPS IDR TPC 7/8 SHORT
RXIF D&I ETHERNET WAN MONITOR
TXIF ENH ASYNC 8QAM
RXLBAND AUPC LDPC 52 MBPS
TXLBAND EDMAC CNC 52 MBPS
RS OM73 SCRAMBLIN EBEM
RS CUSTOM SEQ LOW TX POWER
DVB 8PSK