AMETEK MX CTSL - Manual (Page 97)

User Manual MX-CTSL Compliance Test System
California Instruments Revision J 97
8.2 Tab Controls
The IEC 1000-4-13 Harmonics and Interharmonics test offers range of sub-tests and user options. We
recommend you familiarize yourself with the actual standard document. IEC standards are available
through
www.iec.ch .
The following help screens contain information on setting test options using the available 413 tab controls
located along the top of the IEC 1000-4-13 test window.
Tab Description
Test Setup User selected test options, EUT classes and test steps
Waveforms Flat top curve and Over swing curve definitions
Test Levels Sweep frequency ranges and test levels
Voltage Distortion AC Source voltage distortion monitor display
Waveform Display AC Source measured output waveform display
Resonance Points EUT current as a function of frequency and resonance point summary.
The buttons on the left-hand side of the window may be used to start and stop a test run and print a test
report.
Test parameters for Class X EUT's may be stored on and loaded from disk. This can be done using the
File, Save and File, Open menus.
The results of a frequency sweep may be saved to disk for later recall as well. Data files have a .dat
extension to distinguish them from a test setup file. (.413 extension) The Load and Save Data entries in
the File menu are used for this purpose.