AMETEK MX CTSL - Manual (Page 70)

User Manual
California Instruments
5.5 Running a Harmonics Test
Starting the CTSMXL main program brings up the
automatically sizes to a SVGA
supported but the controls on
Note: For correct harmonics
operated from the same supply
A harmonics test is always started
desired nominal voltage and frequency
for a class A test.
Please note the six fields at the bottom of the set
you entered in these fields are
click OK, you will be presented
specific for the test. The Default
tests are to be performed where
group.
Note: If both the CTSMXL program and the MXGUI
controller to control the
Having both programs
MX-CTSL
Revision J
Test
Starting the CTSMXL main program brings up the test setup screen. This CTSMXL
SVGA display resolution of 800 x 600 pixels. Larger screen
the main window will not size to any resolution above 800
harmonics and flicker measurement operation, make sure that
same supply outlet.
started by setting the desired type and EUT class.
frequency and test window size. The figure below
Please note the six fields at the bottom of the set up screen are grouped as Default
are not necessarily for the particular test you are about
presented with a measurement screen where you can enter
The Default User Input here is intended to facilitate the situations
where the information in Default User Input are applicable
Figure 5-3: Typical Class A test setup
If both the CTSMXL program and the MXGUI are configured to use the same
the AC source, it is important that both programs not be
programs open at the same time could cause an interface conflict.
CTSL Compliance Test System
70
CTSMXL main program window
screen resolutions are
will not size to any resolution above 800 x 600.
that the PACS-3-75 and PC are
Other settings involve the
below shows the typical settings
Default user input. The values
about to perform. When you
enter similar information that is
situations where a group of
applicable to all the tests in the
same Com port or IEEE-488 bus
not be active at the same time.
conflict.