AMETEK MX CTSL - Manual (Page 55)

User Manual MX-CTSL Compliance Test System
California Instruments Revision J 55
The new data acquisition card will appear as a node in the LocalSystem | Hardware | Exacq | PCI/PXI
branch of the System tree.
Click on this node. The serial number and logical device number will display in the Configuration pane. The
logical device number is the identification that application software such as the CTS uses to specify which
hardware device will be used. This device number should only be changed if you have multiple A/D cards
in the PC. See
Figure 3-13 below).
Otherwise, leave the number as is. In the event this is necessary, you may change the assigned device
number by clicking on the configuration tab and selecting a new number using the device number edit
control. Only knowledgeable users should make changes to these settings.
Figure 3-13: Exacq Card Device Number