AMETEK MX CTSL - Manual (Page 60)

User Manual MX-CTSL Compliance Test System
California Instruments Revision J 60
The installation program will create a new entry in the Programs Menu called “CTS MXL”. This menu has
several sub-menu entries, one for the main test program and several for the calibration and configuration
programs as well as a few utility programs. We recommend you keep the calibration and installation CD-
ROM’s in a safe place in case you ever need to re-install the CTSMXL Software.
If the calibration data is not found during the installation process, you still have to option of continuing with
the software installation. A dialog box will prompt you to abort (Cancel) or continue (OK). If you continue,
the calibration data will have to be provided later.
Note: To operate the AC source through the IEEE-488 interface, it may be necessary to install the IEEE-488
controller card drivers on the same PC. Refer to the setup instructions supplied with the IEEE
controller card.
3.9.1 Calibration Data distributed on Floppy Disk
On older CTS systems, the calibration data for each system was distributed on Floppy disk. As this old
medium is rapidly disappearing, CD ROM is used on newer systems.
If the calibration data you received was provided on floppy disk instead of CD ROM, you will have to copy
the following file from this floppy to your hard drive root directory (Usually C:\) using Windows Explorer:
CTSMXL calibration.dat