AMETEK MX CTSL - Manual (Page 59)

User Manual MX-CTSL Compliance Test System
California Instruments Revision J 59
3.9 CTSMXL Software Installation
Once the card drivers have been installed, the CTSMXL Software can be installed next.
The A/D card requires a device driver to be installed. If you did not install the PCI driver and A/D card, go
back to section 3.8.
The MXCTSL system software is supplied on a CD-ROM. The CD-ROM contains compressed files that
are needed to operate MXCTS system properly. Since these files are in compressed form, they should not
be copied to your PC’s hard disk since they will not function in this form. Instead, the setup program that is
included on the CD-ROM should be used to install all the files.
An additional CD ROM is provided containing the system calibration data.
To install the CTSMXL Software, proceed as follows:
1. Insert the CIC652 CD-ROM into your CD-ROM drive and wait a moment for the drive to
recognize the CD.
2. The program should start automatically. If not, select Start->Run… from the Windows Start
menu and type D:\setup.exe, assuming your CD-ROM is the D drive.
3. The CI CD ROM Browser as shown to the
right should now appear on screen.
4. Select MX45-CTSL Series under
Compliance Test Systems in the left hand
side Model Series pane.
5. Next, select the GUI Software Tab on the
right hand side. Then click on the “Execute
Selection” button at the bottom of the
screen.
6. This will bring up the CTSMX Setup
Selector, which is used to copy the
required calibration data to the user’s PC.
Select the version of the CTSMX you want
to install, in this case “CTSMXL System Software Installation (PCI)”.
7. Remove the CIC652 installation CD and replace it with the Calibration Data CD that came with
the CTS system.
8. Click on “Run Setup” and wait for the calibration data to be copied. This will take very little time.
9. You will now be prompted to re-insert the CIC652 installation CD ROM.
10. Remove the Calibration CD and replace it with the CIC652 installation CD. The CI browser may
reappear when you close the CD drive door as your CD drive may be set to autorun. You can
either ignore or close the second instance of the CI Browser program.
11. Click the OK button to confirm that the CIC652 CD is back in the CD ROM drive. This will
launch the CTSMXL installation program.
12. Follow the on screen installation program prompts to complete the CTSMXL system software
setup.
13. Once completed, you can remove the CD-ROM. You may have to reboot the computer after
the software installation. This will be indicated at the end of the installation program.