Adept Lynx Platform User Manual
Page 32
Adept Lynx Platform User's Guide, Rev B
Page 32 of 116
Chapter 2: Setup
Attaching the Floor Plate
Refer to the following figures.
1. Tip the docking station onto its back, so you can access the underside.
2. Remove the two lowest screws (M4 x 12 flat-head), if present.
In the following figure, these screws are circled. The location of the third screw hole is
also circled.
3. Attach the floor plate to the base of the docking station with three M4 x 12 flat-head
stainless steel screws.
The floor plate comes with three screws, so you will have two spares.
The docking station and floor plate do not need to be attached to the floor, as the weight of the
AIV on the floor plate will keep the docking station from moving.
Figure 2-11. Underside of Docking Station Foot, Showing Screw Locations