Adept Lynx Platform - Manual (Page 24)

Adept Lynx Platform User's Guide, Rev B
Page 24 of 116
Chapter 2: Setup
2.4 Repacking for Relocation
If the platform or other equipment needs to be relocated, reverse the steps in the installation
procedures in this chapter. Reuse the original packing crate and materials and follow all safety
notes used for installation. Improper packaging for shipment will void your warranty.
The platform must always be shipped in an upright orientation.
2.5 Operating Environment
The Adept Lynx platform is designed to operate in an environment that is wheelchair access-
ible. Care must be taken to avoid:
l
glass doors and walls
l
pits without railings or low bumpers
l
floors with access panels removed
l
loose cables, hoses, etc.
l
large, highly-reflective objects
Floors must provide good traction, typical of good walking conditions.
l
Slope up to 1:12
l
Step traversal up to 15 mm (0.6 in.)
l
Gap traversal up to 15 mm (0.6 in.)
l
Temperature 5° to 40° C (41° to 104° F)
l
Humidity 5 to 95%, non-condensing
The Adept Lynx platform is not intended for use in hazardous environments (explosive gas,
water, dust, oil mist). It has an IP rating of IP-44.
2.6 Installing a Lynx System
Installing the Battery
Your Adept Lynx platform comes fully-assembled, battery fully-charged.
NOTE: Air shipping regulations require that the platform be shipped without the
battery installed.
Refer to Removing and Installing Covers in the Maintenance section for cover removal and
installation.
1. Remove the inner rear platform cover.
2. Unlatch and open the battery compartment door, at the back of the platform.
The battery compartment door is capable of being locked. You may need to unlock it.