Adept Lynx Platform - Manual (Page 17)

Adept Lynx Platform User's Guide, Rev B
Page 17 of 116
Chapter 1: Introduction
Including a Debuginfo File
If the Lynx platform has been set up on a wireless network, skip to SetNetGo Access on page
18.
Network Setup
If the Lynx platform has not been set up on a wireless network, a local area network will have
to be set up on a separate PC, and configured to talk to the Lynx platform over a TCP/IP port.
The IP address should be set to: 1.2.3.5. The Subnet Mask should be 255.255.255.0.
(XP) Start > Control Panel > Network Connections
Right-click on the LAN Connection. Select Properties.
(Windows 7) Start > Control Panel > (Network and Internet >) Network and Sharing Center
> Change adapter settings
Right-click on the LAN Connection, and click on Properties.
For both XP and Windows 7, from the Properties dialog, scroll to and double-click the Internet
Protocol (TCP/IP or TCP/IPv4) option. In Internet Protocol Properties, click both ‘Use the fol-
lowing…’ radio buttons to enable them, and then type in the IP and netmask values.
Connect the network port of your computer to the platform's maintenance port. See the figure
Location of Parts on the Platform on page 83.