Adept Lynx Platform - Manual (Page 103)

Adept Lynx Platform User's Guide, Rev B
Page 103 of 116
Chapter 8: Maintenance
NOTE: The caster bearing is not centered on the sheet metal that it attaches
to. The caster needs to be mounted as far from the center of the platform as
possible.
11. Return the platform to its upright position.
12. Reinstall the battery, connect the power and data cables, and close the battery com-
partment door.
13. Reinstall the inner rear cover.
14. Reinstall the side covers.
15. Reinstall the payload.
Safety Scanning Laser
1. While supporting the laser, unscrew the two screws and washers from the bracket hold-
ing the laser, to remove the laser from the platform chassis.
Retain these screws and washers for installing the new laser.
2. Unscrew the four screws holding the black plate on top of the laser.
Retain the four screws for reassembly.
You will use this top cap on the new laser. Do not unplug it from the platform chassis.