Xtramus APMPT-4 V2.4 User Manual
Page 86
86
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES
®
B. Transmit
Frame Length Setting: As shown in the figure down below, in a standard Ethernet II frame, the
Frame Length can be from 64~1518 bytes.
By clicking the Frame Length scroll-down menu, you can set the frame length to random (frame
length will be randomly assigned from 64~1518 bytes) or fixed (frame length will be a fixed
number). If you choose fixed as your Frame Length, you can set the frame length in the field
down below.
Packet Setting: You can set how packets will be transmitted in this field.
Total Packet Count: The total amount of packets that will be transmitted for this test.
TxPkt Timeout: If the system fails to send the test packet within the time you set here, the
packet will be drop.
Tx Payload: You can set the content of the transmitting packets with the Payload scroll-down
menu.
T/L(0X):
Packet Gap Setting: You can set the gaps between packets in this field.
Frame Gap: Duration time between frames. Increasing Frame Gap reduces the fail rate, while
96 bit-time is wirespeed.
Collision release gap: Time slot of conflict avoidance under half-duplex mode.
VLAN Setting: Add VLAN tag for test. VLAN (Virtual LAN) is a group of hosts with common
requirements that communicate within the same Broadcast domain regardless of the physical
location. By clicking the Setup button, you can configure CoS (class of service) and VID (VLAN ID)