Xtramus APMPT-4 V2.4 - Manual (Page 8)

8
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
B. Flow Control Test
Perform flow control test on DUT in layer 2 with different speeds, modes and various configurations. It
tests the performance when the DUT is connected to the media type with varied kinds of speeds and
directions.

PT2-FC-10H-100H (10Mbps Half
↔ 100Mbps Half),
 PT2-FC-100H-10H (100Mbps Half ↔10Mbps Half),
 PT2-FC-10F-100F (10Mbps Full ↔ 100Mbps Full),
 PT2-FC-100F-10F (100Mbps Full ↔ 10Mbps Full),
 PT2-FC-100F-1G (100Mbps Full ↔ 1Gbps Full),
 PT2-FC-1G-100F (1Gbps Full ↔ 100Mbps Full),

PT2-FC-1G-10G (1Gbps Full
↔ 10G Full),

PT2-FC-10G-1G (10G Full
↔ 1Gbps Full),
 PT2-FC-GROUPS (Perform Layer 2 Flow Control tests by two groups with different media types
such as 100Mbps and 1Gbps for DUT ports with different maximum speeds.)
C. Broadcast Test
Broadcasting refers to transmitting packets that will be received (conceptually) by every device on the
network.
Perform broadcast test on DUT in layer2 with different speeds, modes and various configurations.
These following tasks transmit broadcast frames (Destination Address: FF:FF:FF:FF:FF:FF).
 PT2-BC-10H, (10Mbps, Half Duplex)
 PT2-BC-10F, (10Mbps, Full Duplex)
 PT2-BC-100H, (100Mbps, Half Duplex)
 PT2-BC-100F, (100Mbps, Full Duplex)
 PT2-BC-1G, (1Gbps, Full Duplex)

PT2-BC-10G, (10Gbps, Full Duplex)

PT2-BC-GROUPS (Perform Layer 2 Broadcast test by two groups with different media types such
as 100Mbps and 1Gbps for DUT ports with different maximum speeds.)