Xtramus APMPT-4 V2.4 - Manual (Page 10)

10
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
1.3.3. Performance Tasks in Layer 3 (PT3)
A. Network Tool: Ping
Ping is a network tool used to test whether a particular host is reachable across an IP network. It is also
used to self-test the network interface card of the computer, or as a speed test.
Perform Ping test on DUT in layer3 that is based on different IP addresses, subnet mask, ping IP address
and gateway.

PT3-Ping
B. Unicast Test
Unicast transmission is to send information packets to a single destination. In layer 3 test, unique IP
address is the key of single destination as illustration below.
Perform unicast test on DUT in layer 3 with different speeds, mode and various configurations.
 PT3-UC-10H, (10Mbps, Half Duplex)
 PT3-UC-10F, (10Mbps, Full Duplex)
 PT3-UC-100H, (100Mbps, Half Duplex)

PT3-UC-100F, (100Mbps, Full Duplex)

PT3-UC-1G, (1Gbps, Full Duplex)
 PT3-UC-10G, (10Gbps, Full Duplex)
 PT3-UC-GROUPS (Layer 3 Unicast Full Performance Test. Perform Layer 3 IP Address Unicast
test by two groups with different media types such as 100Mbps and 1Gbps for DUT ports with
different maximum speeds.)