Xtramus APMPT-4 V2.4 User Manual

Page 65

Website: www. Xtramus.com

XTRAMUS TECHNOLOGIES

packets with CRC error is higher than the amount you set here, the test fails. You can set the amount

by two ways: By Quantity

and By Percentage



Enable Latency Check: enable the latency check function. There are two optional latency

calculation modes, namely Cut-Thought and Store-and-Forward. You can set the acceptable

latency in the red rectangle field, shown as the picture down below. If the latency exceeds the value

you set here, the test will fail. And this function is unavailable when the Frame Length is set to be

random.



Enable line Rate Check: enable the line rate check function. You can set the lowest line rate in the

red rectangle field, shown as the picture down below. If the line rate is lower than the value you set

here, the test will fail.