Haltcc, Initcfg, List – Altera Quartus II Scripting User Manual
Page 78: Mode= on
2–52
Chapter 2: Command-line Executables
quartus_pgm
Quartus II Scripting Reference Manual
© July 2013
Altera Corporation
The following syntax is supported for backward compatibility, as is the cable index (the number returned
by jtagconfig to identify a cable):
Examples:
ByteBlasterMV
"byteblaster [lpt1]"
"USB-Blaster on remote-machine [com1]"
APU
--haltcc
Halts the on-chip auto-configuration controller of the device to allow programming via the JTAG interface.
--initcfg
Specifies that configuration devices will configure attached devices automatically after the Programmer
finishes programming the configuration devices.
--list
Option to display all the available programming hardware cables.
--mode=
Option to specify which programming mode to use.
Use one of the following programming mode values:
--operation=
Option to specify which programming operation(s) to perform on the device(s).
Use the following syntax for each device in a device chain:
-o
NOTE: The device index starts with 1.
Exceptions to this syntax occur when you use the following options:
-o E;
-o S;
P, BP, PV, BPV,
PL, BPL, PVL, BPVL
CP, CBP, CPV, CBPV,
CPL, CBPL, CPVL, CBPVL
IP, IBP, IPV, IBPV,
Value
Mode
JTAG
JTAG programming
PS
Passive Serial programming
AS
Active Serial programming
SD
In-Socket programming