Altera Arria 10 Avalon-MM - Manual (Page 21)

Generating the Example Design
1. On the Generate menu, select Generate Testbench System. The Generation dialog box appears.
2. Under Testbench System, set the following options:
a. For Create testbench Qsys system, select Standard, BFMs for standard Qsys interfaces.
b. For Create testbench simulation model, select Verilog.
3. You can retain the default values for all other parameters.
4. Click Generate.
5. After Qsys reports Generation Completed, click Close.
6. On the File menu, click Save.
The following table lists the testbench and simulation directories Qsys generates.
Table 2-1: Qsys System Generated Directories
Directory Location
Qsys system /ep_g2x4_avmm128_tb
Simulation Directory /ep_g2x4_avmm128_tb/ep_g2x4_tb/sim/
The design example simulation includes the following components and software:
• The Qsys system
• A testbench. You can view this testbench in Qsys by opening /ep_g2x4_avmm128_tb/ep_
g2x4_avmm128_tb.qsys .
• The ModelSim software
Note: You can also use any other supported third-party simulator to simulate your design.
Complete the following steps to run the Qsys testbench:
1. In a terminal window, change to the
/ep_g2x4_avmm128_tb/ep_g2x4_avmm128_tb/sim/
mentor directory.
2. Start the ModelSim ® simulator.
3. Type the following commands in a terminal window:
a.
do msim_setup.tcl
b.
ld_debug
c.
run 140000 ns
UG-01145_avmm
2015.05.14
Generating the Example Design 2-3
Getting Started with the Avalon‑MM Arria 10 Hard IP for PCI Express Altera Corporation
Send Feedback