EXFO FIP-400B Fiber Inspection Probe and ConnectorMax2 - Manual (Page 63)

Inspecting Fiber Ends
Fiber Inspection Probe 57
Inspecting Fiber Ends (Multifiber)
14. View results on screen.
Note: The auto-focus starts automatically only for the first fiber (FIP-430B only).

Hold the magnification control button located on the probe for
one second to reactivate the auto-focus process (FIP-430B only).
OR

Adjust focus manually.
15. If the fiber end is dirty, remove it from the probe, clean it and
reinspect it.
16. When in high magnification level, press Capture.
OR
Press the Fiber Inspection Probe handset button.
17. If you are not using the batch inspection feature, return to Live Video
mode. Repeat steps 13 to 17 until you reach the end of the connector.
18. If you are using the batch inspection feature, press Process.
OR
To continue the current connector inspection, return to Live Video
mode.
19. To inspect a new connector, tap File, then New.