Echelon LNS DDE Server - Manual (Page 120)

PCLTA-10, PCLTA-20, and PCC-10 Adapter Installation
The PCLTA-10, PCLTA-20, and PCC-10 installation software installs the files
required by the Windows XP, Windows 2000, Windows NT 4.0, Windows Me, or
Windows 98 operating systems to recognize the PCLTA-10, PCLTA-20, and PCC-
10 adapters. Therefore, installation of the software must precede insertion of
the adapter into a PC ISA (PCLTA-10), PCI (PCLTA-20), or PCMCIA PC Card
(PCC-10) slot.
If you are installing a PCLTA-10 or PCLTA-20, once the software has been
installed, you must shut down the PC, install the appropriate hardware as
described in Hardware Installation Procedure, later in this chapter, and re-start.
If you are installing a PCC-10, you can install the hardware without shutting
down the PC; however, the computer must be rebooted between the installation
of the driver software and the hardware. Then you must load the PCL10VNI
(PCLTA-10 and PCLTA-20) or PCC10VNI (PCC-10) application into the
hardware and run a diagnostic to ensure it is communicating correctly as
described in PCLTA-10, PCLTA-20, and PCC-10 Configuration Procedure.
PCLTA-10, PCLTA-20, and PCC-10 Software Installation
Procedure
To install the PCLTA-10, PCLTA-20, and PCC-10 software follow these steps:
1. Start the installation procedure as described in LNS DDE Server in Chapter
2. Select the PCLTA-10/20/PCC-10 driver in step 6.
2. At the end of the installation procedure, the LNS DDE Server installation
program will start the PCLTA-10, PCLTA-20, and PCC-10 driver installation
program. The following Installation Language Options dialog opens.
B-2 Installing the PCLTA-10/20 and PCC-10 Drivers