Echelon Mini FX - Manual (Page 69)

56 Using the Mini FX Application
2. In the Network Interface box, select the network interface attached to your
development computer that is to be used for communication between the Mini FX
Application and your EVB, and then click Connect. If you are using the U10 or U20
USB Network Interface included with the Mini kit and you have not installed any
other network interfaces on your computer, select LON1. The Status box at the
bottom indicates whether the Mini FX Application is connected to a network
interface.
You can alternatively use a different layer 5 network interface such as a PCC-10,
PCLTA-20, PCLTA-21, i.LON 10 Ethernet Adaptor, i.LON server. To use a PCC-10,
PCLTA-20, PCLTA-21 as the network interface for communication with an FT 5000
EVB, you must first configure it as a layer 5 interface. To do this, click Start on the
taskbar, click Control Panel, and then double-click LonWorks Plug ‘n Play. In
the Device Selected box, select your network interface. In the NI application box,
select PCC10NSI if you are using a PCC-10, or select NSIPCLTA if you are using a
PCLTA-20 or a PCLTA-21. Click OK to save your changes and close the LonWorks
Plug ‘n Play application.