Echelon Mini FX - Manual (Page 59)

46 Mini FX Quick-Start Exercise
Figure 3-2 demonstrates that the device application in this quick-start exercise has
successfully been downloaded to the EVB. In addition, it displays the properties set
in the Device tab to download the device application.
Figure 3.2 Downloading the Device Application
Step 5: Testing the Device Application
You can use the switch and LED I/O devices on your EVB to test your device application,
and verify that it is functioning as designed. To test your device application, follow these
steps:
1. Press the SW1 button located on the bottom left side of the FT 5000 EVB or Mini
Gizmo I/O board.
2. Observe that LED1 is illuminated (LED1 is located directly above the SW1 button).
3. Press the SW1 button to extinguish LED1.