Echelon i.LON 600 LonWorks/IP Server - Manual (Page 91)

Section 3: Appendixes
i.LON 600 Ports
The i.LON 600 uses IANA designated ports for LonWorks traffic (ports 1628 and 1629).
Continuing with the above example, you could connect an i.LON 600 to your network
with an IP address of 192.168.1.102.
Home Network
192.168.1.100
192.168.1.101
192.168.1.1
NAT
Gateway
LAN Side
WAN Side
131.28.203.17
ISP Internet
WAN Side Address is
Provided by ISP (assigned)
i.LON 600
192.168.1.102
Figure 42. Adding an i.LON 600 to an NAT Gateway
To allow Internet access to your i.LON 600, you must map the necessary ports on your
NAT gateway (as you did for the PCs when setting up web access). Once port 1628 is
mapped to 192.168.1.102, the NAT gateway will forward any requests from peer i.LON
600s or from the Configuration Server.
i.LON 600s can be configured to use ports other than the IANA defaults. This allows
multiple i.LON 600s to reside behind a single NAT gateway. The i.LON 600 allows you
to configure various parameters through the setup Web page using a limited Web server.
The default port for this Web server is port 80. In the example, port 80 is already used by
192.168.1.100, so you must change the port on the i.LON 600 and enter two static
mappings into the NAT gateway:
Port 1628 Æ 192.168.1.102
Port 82 Æ 192.168.1.102
Consult your NAT gateway owner’s manual for details on how to setup static port
mapping for your particular NAT gateway.
i.LON 600 User’s Guide 83