ADLINK aTCA-N700 - Manual (Page 21)

aTCA-N700 HW Users Guide
２１
4.1.3. Programmable Devices
There are programmable devices with their own images on the board. The board is
provided with default images programmed for all the mandatory devices, and most of
them are upgradable as described in
Table 4-6 .
Table 4-6 Programmable devices
Component Part Number Content Remarks
NAND flash memory
MT29F16G08AB
ABA Linux and user
application
SPI flash memory SST25VF080B Uboot image
IPMC
A2F500M3G-
FGG484I
IPMC image
EEPROM M24256 (256Kb) IPMI variables
NOR flash memory
JS48F4400P0TB
00A Linux and user
application
Optional to
replace NAND
flash
Micro-SD card 4GB
Linux and user
application
CPLD
LCMX0640C-
3FTN256C
CPLD Image
4.2. Hardware Installation
The steps required to install the ATCA-N700 are the following: Front Blade installation,
RTM installation, Monitoring Station connection, and Traffic Port connection.
4.2.1. Front Blade
The board should be plugged in as per the following procedures:
Step 1: The injector handles (top and bottom) shown in Figure 4-6 should be
opened to plug the board into a chassis slot.
Step 2: The board should be aligned on to the rail (marked as (A)) in the reserved
slot for the board
Step 3: Slide the board into the chassis until the guide of the faceplate and the
hole of the chassis meet as in (B)
Step 4: Once the guide of the faceplate slides into the hole, close the upper
injector handle so that the handle wedge goes into the handle hole and makes a
click sound.