TeeJet RX 400p - Manual (Page 92)

RX 400p
98-05044 4-50
R1
Remote Site
When the RX 400p displays ‘OK’, this menu item
indicates that the remote site in use as part of the
DGPS correction source is operating correctly. If the
site is not operating correctly, the receiver will
display ‘BAD’.
Almanac
This menu item indicates if the almanac provided by
the OmniSTAR services has been downloaded
successfully. If a valid almanac is present with the
RX 400p, it will display ‘OK’, otherwise the receiver
will display ‘BAD’. A valid almanac is required to
decode DGPS data. It may take up to 20 minutes to
obtain a valid almanac if the current one is invalid or
out of date. A valid almanac is present from factory.
Position
This menu item indicates if the internal L-band
receiver has received a position from the GPS sensor.
If a valid position is present, the RX 400p will
display ‘OK’, otherwise the receiver will indicate
‘BAD’.
Time
This menu item indicates if GPS time is currently
available to the internal L-band sensor. If time is
available, the RX 400p will display ‘OK’, otherwise
the receiver will display ‘BAD’.
Sat?Update
This menu item indicates if the current satellite
update is correct. If the current update is acceptable,
the RX 400p will display ‘OK’, otherwise the
receiver will display ‘BAD’.