TeeJet RX 400p - Manual (Page 113)

RX 400p
4-71 98-05044
R1
4.16.1 Changing the Source of DGPS Corrections
To change the source of corrections used by the internal GPS sensor within the RX
400p receiver:
Using the or key, move the DGPS menu, located in the root menu, into focus
and press . For example, when in WAAS mode, this menu will be called WAAS@.
Press to move the Configure@ menu item in focus and press .
If required, press to move the Diff@ menu item into focus and press .
Select the desired differential correction source (WAAS, OmniSTAR, beacon,
Extern RTCM, or Autonomous) using the
or keys and press .
4.16.2 Changing the Output Data Messages
To change data messages output by the RX 400p receiver:
Using the or key, move the GPS@ menu, located in the root menu, into focus
and press .
Press to move the Configure@ menu item in focus and press .
Press to access the NMEA I/O@ menu.
Adjust the message output as necessary by moving the desired message into focus
using the
or key and press .
Adjust the output rate to that desired using the or key and pressing the
button.
Continue for each data message as required.
4.16.3 Changing the Baud Rates
To modify the baud rate of the RX 400p data ports:
Using the or key, move the Setup@ menu, located in the root menu, into
focus and press .
Using the or key, move the Baud?Rates@ menu into focus and press .