TeeJet RX 400p - Manual (Page 143)

RX 400p
10-1 98-05044
R1
10 Appendix C - Activating the
OmniSTAR DGPS Service
10.1 L-band Receiver Unit Number
To use the OmniSTAR service, your receiver must be operating in OmniSTAR mode
with a valid subscription. In order to subscribe your RX 400p receiver’s internal
OmniSTAR sensor, you must know its unit number.
To determine the unit number of the internal L-band DGPS receiver inside your RX
400p receiver, follow these instructions:
Turn the RX 400p receiver on
Once the boot sequence has completed, ensure that the internal OmniSTAR sensor is
currently selected as the DGPS source. If the second menu item shows
OmniSTAR@
, then the L-band sensor is currently being used. If this is not
displayed, you must change to the use of the internal L-band receiver. See Section
4.16.1 for information on changing the DGPS source.
Access the OmniSTAR@ menu in the current level of the menu system using either
or and press .
Use either or to cycle the menu system so that Configure@ is in focus and
press .
Press or until Subscription@ is in focus and press .
Use either or to move the SerialNum?Disp@ menu item into focus and
press to access this feature.
The serial number of the internal SLX receiver will be displayed
When you access the SerialNum?Disp@ menu item, the RX 400p receiver will
display the unit number (serial number) of the SLX engine. Please record the unit
number so that you may provide it to OmniSTAR when activating your service.