TeeJet RX 400p - Manual (Page 142)

RX 400p
98-05044 9-4
R1
Figure B-3 illustrates the required interface between the RX 400p and an external
GPS receiver:
3 RX RTCM
5 GND GND
TX
A U X
External C orrection Source
Figure B-3 External Correction Source Interface
Note - For successful communications, the baud rate of the RX 400p AUX port
must be set to match that of the external correction source. Additionally, you
must interface the RX 400p to an RS-232C serial port of the external source.
Refer to Section 4.15.3 for instructions related to setting the RX 400p baud rate.