TeeJet RX 400p - Manual (Page 31)

RX 400p
1-11 98-05044
R1
1.5 Mounting Accessories
MID-TECH offers various mounting accessories as discussed in the following
sections.
1.5.1 Magnetic Mount
Included with a standard system, the magnetic mount (PN 725-0007-012) can be used
to install the CDA-2B antenna on any ferrous surface including the roof of a vehicle.
It consists of a mounting extension two inches long, attached to a circular metal disk,
housing a magnet. A protective membrane covers the bottom of the mount protects
the mounting surface from abrasion.
A three inch diameter zinc plated steel disc and a double sided adhesive foam pad are
included with the magnetic mount to attach the magnetic mount to non-ferrous
surfaces, such as fiberglass rooftops. For such an installation, remove the protective
backing from both sides of the adhesive foam pad, and affix the foam pad to the non-
ferrous surface. Place the disc on top of the foam pad. You can then place the
magnetic mount securely on the metal plate, and remove as necessary.
The threaded shaft of the mount may be removed from the magnetic disk and used as
a threaded insert for survey applications that use the common 5/8
th -inch thread. The
MID-TECH part number for the threaded shaft is 78-50069.
1.5.2 Survey Adapter
The optional Survey Adapter is a threaded insert available for use with the CDA-2B
antenna. It converts the standard 1-14-UNS-2B thread to a 5/8
th -inch thread,
frequently used with survey equipment (MID-TECH PN 78-50069). This survey
adapter is the same part as used for the shaft of the magnetic mount