TeeJet RX 400p - Manual (Page 48)

RX 400p
98-05044 4-6
R1
4.4.6 Autonomous Mode Icon
The Icon shown in the following figure indicates that the receiver is configured to
position autonomously, with no DGPS correction source.
@
Figure 4-8 Autonomous Mode Icon
4.5 RX 400p Menu System Overview
This section shows you how to navigate through the menu system of the RX 400p
receiver, change operating modes, monitor position and status information, and
change receiver configuration. Figures 4-9 to 4-15 illustrate the various menus in the
menu system.
The root, or main menu, contains main parent menus - a GPS menu, a differential
menu, a Configuration Wizard menu, and a System Setup menu.
The GPS, Configuration Wizard, and System Setup menus remain the same
regardless of the operating settings of the RX 400p receiver. However, the name and
content of the differential menu depends on the differential correction source
currently in use. Available DGPS operating modes include WAAS, OmniSTAR,
Beacon, Autonomous, and External RTCM Input mode.
In Figures 4-9 to 4-15, the root menu is displayed on the left, with associated
submenus displayed progressively towards the right. Each of the figures is described
in the following sections in detail.