TeeJet RX 400p - Manual (Page 114)

RX 400p
98-05044 4-72
R1
Depending on which baud rate you with to change, Use the or key to move
either the DATA?1@ or DATA?2@ menu into focus and press .
Scroll with the or keys to the required baud rate and press .
4.16.4 Monitoring the OmniSTAR Subscription Status
When in OmniSTAR DGPS mode, to view the subscription status of the OmniSTAR
engine inside the RX 400p receiver:
Using the or key, move the OmniSTAR@ menu, located in the root menu,
into focus and press .
Using the or key, move the Configure@ menu into focus and press .
Use the or key to move the Subscription@ menu into focus and press
.
Press to access the Expiry?Date@ menu that provides the current expiration
date of the internal subscription. If the subscription date provided is older than your
current date, the subscription has expired or is not present.
4.16.5 Tuning the Internal Beacon Sensor
When operating in beacon DGPS mode, there are a few different ways to tune the
beacon engine within the RX 400p.
4.16.5.1 Change Beacon Frequency and MSK Rate
To modify the frequency and MSK rate to which the receiver is manually tuned:
Using the or key, move the Beacon@ menu, located in the root menu, into
focus and press .
Using the or key, move the Configure@ menu into focus and press .
Use the or key to move the Tune@ menu into focus and press .
Using the or keys, adjust the frequency and MSK bit rate to the values that
you desire and press . You may select a beacon within the 283.5/100 to
Auto/Auto range of values.