TeeJet RX 400p - Manual (Page 120)

RX 400p
98-05044 5-4
R1
When choosing ‘Yes’, the menu system will display the five memory locations and
allow you to choose one configuration, or exit the Wizard with no changes to the
current configuration.
5.4 Bypassing a Configuration Step
The Wizard process prompts you for each step by asking if you wish to configure the
specific parameter mentioned. You may choose ‘No’ and go on to the next step, thus
bypassing the current step.
When bypassing the current step, the parameter that was bypassed will remain
unchanged from your current configuration. For example, if the RX 400p is
operating in WAAS mode, and during the Wizard step-by-step process you are
prompted to choose the DGPS source, if you are happy with the current WAAS
mode, select ‘No’. This will maintain WAAS mode and allow you to proceed on to
the subsequent configuration parameters in the Wizard.
5.5 Completing the Step-by-Step Process
When completing the Configuration Wizard, by pressing the button with
Finish@ in focus, the Wizard will indicate that it’s configuring the DGPS source,
followed by configuring the receiver. This will complete the step-by-step process
and takes a few seconds. You will then be prompted to save the new configuration
for later use, if desirable.
5.6 Saving a Configuration
When completing the Configuration Wizard, you will be prompted to save your new
configuration or simply proceed with the new configuration. If you wish to save the
new configuration for future use in the Wizard Table, you will be prompted to select
one of the five memory locations for saving.
Within this stage of the Configuration Wizard, you may continue without saving the
new configuration by selecting Exit Wizard@.