Compaq 3200 - Manual (Page 29)

2-9
Compaq Smart Array 3200 Controller Reference Guide
Writer: Rickard Project: Compaq Smart Array 3200 Controller Reference Guide Comments: 340862-002
File Name: C-CH02.DOC Last Saved On: 12/7/98 8:33 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
To move an array, make sure all required conditions are satisfied, then:
1. Power-down the system.
2. Move array (including all drives in the array).
3. Power-up the system. A 1727 POST message should indicate that logical
drives were added to the configuration. If a 1785 (Not Configured)
POST message is displayed, turn the system off immediately to avoid
data loss and return the drives to their original locations.
NOTE: If you move arrays from a dual-channel controller to a single-channel
controller, you may get an error message indicating a configuration error. If you
get this error message:
❏ Return to the previous dual-channel controller configuration.
❏ Back up data on the array.
❏ Move the drives to the single-channel controller.
❏ Run the Array Configuration Utility on the single-channel controller to
configure the array.
❏ Restore data to the array.
4. Run the Array Configuration Utility to view the new drive configuration
or to assign spare drives (optional).