Compaq 3200 - Manual (Page 100)

6-18 Installing the Operating System Drivers
Writer: Rickard Project: Compaq Smart Array 3200 Controller Reference Guide Comments: 340862-002
File Name: G-CH06.DOC Last Saved On: 12/7/98 9:23 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Installation Procedures
Device drivers can be installed in a Windows NT server using:
■ The Compaq SSD for Windows NT Setup program installation
or
■ The standard Windows NT device driver installation
Both methods are outlined in this chapter. Compaq recommends the Compaq
SSD for Windows NT Setup program installation method.
Compaq SSD for Windows NT Setup
Program Installation Method
The Compaq SSD for Windows NT Setup program installation method uses
device drivers installed with the Setup program located on the Compaq SSD for
Windows NT. The Setup program identifies hardware components installed in
the machine and suggests device drivers needing installation.
Use the following steps to run the Compaq SSD for Windows NT Setup
program:
1. Start Windows NT 3.51 or 4.0 and log in to an account with
administrative privileges.
2. Insert the Compaq SSD for Windows NT Support Software Diskettes,
one at a time, into the diskette drive.
3. From the Program Manager, select File
→
Run.
4. Enter the following:
A:\setup