Remove the +1 adaptor module, Red dsmc operation guide – RED DSMC User Manual

Page 38

Text mode
Original mode

RED DSMC OPERATION GUIDE

955-0020_V5.3, REV-J | 38

4. Insert the HDMI connector into the HDMI port on the BRAIN.

5. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2)

turns each using a T20 Torx driver. DO NOT FULLY TIGHTEN.

6. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T20 Torx driver.

WARNING: DO NOT OVERTIGHTEN.

REMOVE THE +1 ADAPTOR MODULE

REQUIRED TOOL: T20 Torx driver
1. Turn off the BRAIN.
2. Loosen the four (4) captive mounting screws in a cross pattern (“X” pattern) using a a T20 Torx driver.
3. Disconnect the HDMI connector from the BRAIN.
4. Remove the +1 Adaptor Module from the BRAIN.

Insert the HDMI

connector to the

BRAIN

Tighten screws