Positive lock (pl) lenses, Attach pl lenses, Detach pl lenses – RED DSMC User Manual

Page 199: Canon ef lenses, Attach canon ef lenses, Detach canon ef lenses, Red dsmc operation guide

RED DSMC OPERATION GUIDE

955-0020_V5.3, REV-J | 199

POSITIVE LOCK (PL) LENSES

This section describes the appropriate method for attaching and detaching PL lenses.
For more information, refer to the original manufacturer’s instructions.
WARNING: ALWAYS protect your equipment, when it is not in use, by replacing lens caps and mount caps.

ATTACH PL LENSES

1. Rotate the lens mount frame counter-clockwise to release the DSMC mount cap.
2. Remove the rear lens cap and the DSMC mount cap.
3. Align the key and contact pads (if present) on the PL lens with the key and connector pins on the DSMC

PL mount.

4. Insert the lens into the PL mount.
5. Rotate the lens mount frame clockwise to secure the lens in place.

DETACH PL LENSES

1. Rotate the lens mount frame counter-clockwise to release the PL lens.
2. Remove the PL lens from the DSMC PL mount.
3. Replace the rear lens cap and DSMC mount cap when the lens is not in use.

CANON EF LENSES

This section describes the appropriate method for attaching and detaching Canon EF lenses.
For more information, refer to the original manufacturer’s instructions.
WARNING: ALWAYS protect your equipment, when it is not in use, by replacing lens caps and mount caps.

ATTACH CANON EF LENSES

1. Rotate the secondary locking clamp counter-clockwise to disengage.
2. Press the lens release button and rotate the lens cap counter-clockwise to remove the DSMC mount cap.
3. Remove the rear lens cap.
4. Align the red dot on the lens with the red dot on the DSMC Canon Mount and position the lens in the mount.
5. Turn the lens clockwise until it clicks into place.
6. Rotate the secondary locking clamp clockwise to engage.

DETACH CANON EF LENSES

1. Rotate the secondary locking clamp counter-clockwise to disengage.
2. Press and hold the lens release button. While holding the lens release button, turn the lens counterclockwise

until it stops and remove it from the DSMC mount.

3. Replace the rear lens cap and DSMC mount cap when the lens is not in use.