RED DSMC - Manual (Page 144)

COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.3, REV-J | 144
DOCK TO PAIR
1. Turn on the BRAIN.
2. Dock the REDMOTE to the back of the BRAIN or rear module.
NOTE: When the REDMOTE is removed from the DSMC, it automatically scans for the wireless signal and
connects to that DSMC.
PAIR WIRELESSLY
1. Turn on the BRAIN.
2. Go to Menu > Settings > Setup > REDMOTE.
3. Select Scan for REDMOTEs.
4. When the scan is complete, select the REDMOTE from the scan list.
5. Select Pair ->.
6. Select Close to exit the menu.
NOTE: To see the REDMOTE MAC address, go to Setup > Setup System. The MAC address displays at the
bottom of the LCD.
7. On the REDMOTE, press Button 2.
The Connect Menu opens.
8. On the REDMOTE, use the Scroll Wheel or Directional Keys to select the DSMC from the list and press ENTER.
If the DSMC does not display, select RESCAN... and press ENTER. If the DSMC is still missing from the list,
ensure that DSMC settings are properly configured in the Communication and REDMOTE menus.
RECONNECT REDMOTE TO A PAIRED CAMERA
Follow the instructions below to reconnect the REDMOTE to a DSMC that is has been to paired to before.
1. Press Button 1 to scan for paired cameras within wireless range. A scan takes about 20–30 seconds.
NOTE: The Connect Menu is hidden on the LCD when the REDMOTE is attached to a camera or rear module.
2. Select the camera and press Enter.
The REDMOTE connects to the selected camera.
NOTE: If the REDMOTE fails to find a camera within range, select Rescan and press ENTER in the Navigation
Group to force a second scan.
RECONNECT THE REDMOTE AFTER SIGNAL LOSS
On loss of wireless communication, the REDMOTE scans for the camera it was last paired with. If the REDMOTE
is unable to reconnect after 30 seconds, the manual Scan menu opens.
DISCONNECT THE REDMOTE FROM A PAIRED DSMC
1. Press Button 1.
2. Select DISCONNECT.
3. Press ENTER.