Install the module adaptor, Red dsmc operation guide – RED DSMC User Manual

Page 36

Text mode
Original mode

RED DSMC OPERATION GUIDE

955-0020_V5.3, REV-J | 36

INSTALL THE MODULE ADAPTOR

You must install an adaptor module on the back of the BRAIN before you install a DSMC module.
REQUIRED TOOL: T20 Torx driver
1. Turn off the BRAIN.
2. Remove the REDMOTE, if attached.
3. Position the Module Adaptor over the V-mount on the rear of the BRAIN.

4. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2)

turns each using a T20 Torx driver. DO NOT FULLY TIGHTEN.

5. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T20 Torx driver.

WARNING: DO NOT OVERTIGHTEN.

Install Module Adaptor

Tighten screws