Remove the module adaptor, Install the +1 adaptor module, Red dsmc operation guide – RED DSMC User Manual

Page 37

Text mode
Original mode

RED DSMC OPERATION GUIDE

955-0020_V5.3, REV-J | 37

REMOVE THE MODULE ADAPTOR

REQUIRED TOOL: T20 Torx driver
1. Turn off the BRAIN.
2. Use a T20 Torx driver to loosen the screws attaching the Module Adaptor to the BRAIN.

3. Remove the Module Adaptor from the BRAIN.

INSTALL THE +1 ADAPTOR MODULE

REQUIRED TOOL: T20 Torx driver
1. Turn off the BRAIN.
2. Remove the REDMOTE, if attached.
3. Position the +1 Adaptor Module over the V-mount on the rear of the BRAIN.

Install the +1 Module

Adaptor