Redmote basics, Dock the redmote, Undock the redmote – RED DSMC User Manual

Page 143: Turn on the redmote, Turn off the redmote, Record start/stop, Pair the redmote, Red dsmc operation guide

RED DSMC OPERATION GUIDE

955-0020_V5.3, REV-J | 143

REDMOTE BASICS

This section describes the common REDMOTE operations.

DOCK THE REDMOTE

1. Position the REDMOTE V-Mount dock over the V-Mount on the BRAIN or rear module.
2. Slide the REDMOTE down until you hear a click, which indicates the REDMOTE is securely attached.
NOTE: Docking the REDMOTE automatically pairs the REDMOTE with the camera when the DSMC is turned on

and wireless settings are enabled.

UNDOCK THE REDMOTE

1. Press both Release buttons, located on the sides of the REDMOTE.
2. Slide the REDMOTE up to release from the V-Mount on the BRAIN or rear module.
3. Remove the REDMOTE.

TURN ON THE REDMOTE

When docked, the REDMOTE automatically turns on when the DSMC is turned on.

Slide and hold the Power/Key Lock switch in the down position for two (2) seconds, then release.

TURN OFF THE REDMOTE

When docked, the REDMOTE automatically turns off when the camera is turned off.

Slide and hold the Power/Key Lock switch in the down position for five (5) seconds, then release.

Slide and hold the Power/Key Lock switch in the down position momentarily, then release. Select the desired

option from the Shutdown menu and press Enter:

‒ Shutdown Cam + REDMOTE: Turn off both DSMC and the REDMOTE

‒ Shutdown REDMOTE: Turn off the REDMOTE only.

‒ Shutdown Camera: Turn off the DSMC only. Option not available when the REDMOTE is docked.

NOTE: For maximum battery life, remove power from the REDMOTE by pressing the Power/Lock Switch down

into the off position and release. Then use the menu to turn off the device. When turning off the REDMOTE using

the Power/Lock Switch, a slight power draw remains and continues to drain the battery.

RECORD START/STOP

Start Record: Press and release the REC button. The Power/Recording LED illuminates red and the Timecode

value on the LCD display changes to red text.

Stop Record: Press and release the REC button. When media recording processes are complete, the Power/

Recording LED turns off and the Timecode value on the LCD display changes back to white text.

PAIR THE REDMOTE

There are two (2) ways to pair the REDMOTE to a DSMC:

Dock to pair

Pair wirelessly

When a REDMOTE and DSMC are paired:

The REDMOTE displays the DSMC settings.

VIEWFINDER ouputs display green RM status and signal strength indicators in the Lower Status Row.

NOTE: You can pair the REDMOTE to multiple BRAINs. However, you can only control one BRAIN at a time.