RED DSMC - Manual (Page 114)

COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.3, REV-J | 114
REDISCOVER (HARDWARE REDISCOVER)
Rediscovers all hardware and caches the data for future boot cycles. Perform a Hardware Rediscover if a
module or lens mount is not functioning correctly.
To perform a Hardware Rediscover, follow the instructions below:
1. Go to Menu > Settings > Maintenance.
2. Select Rediscover.
3. Select Yes on the screen that asks you to confirm the Hardware Rediscover.
The BRAIN turns off.
4. Turn on the BRAIN.
SYSTEM STATUS
The System Status menu displays key project and system information on the following tabs: Project Status,
Module Status, Camera Info, and Media Info.
PROJECT STATUS
Displays the current camera and project settings.
MODULE STATUS
Displays which modules are attached to the BRAIN.
Not Detected: The module is either not attached, or is not detected by the BRAIN.
Attached: The module is attached and detected.
CAMERA INFO
Displays the following camera information:
Model: Camera type (EPIC or SCARLET) and sensor type.
Version: Current firmware version.
P.I.N.: The personal identification number that is specific to your camera.
SVN revision: The current firmware number.
Hours of operation: The number of hours that the camera has been turned on.
MEDIA INFO
Displays the following media information:
Media Status: Active media, module type.
Media Name: Storage capacity, SSD type, and version/revision of the SSD.
Serial Number: Serial number of the SSD.
Media Firmware Revision: Firmware version of the SSD.
Media Size: Total capacity on the SSD.
Media Space Available for Recording: Total capacity left on the SSD that can be recorded to.
Maximum Data Rate: The maximum data rate when writing files to the SSD.
Current Estimated Record Data Rate: The current data rate for writing files to the SSD.
NOTE: When an SSD is not attached, the Media Info tab displays “No Active Media is Present”.