beautypg.com

Bypassing individual commands – Juniper Systems Allegro DOS Manual User Manual

Page 93

background image

Allegro DOS Owner’s Manual 93

Bypassing Individual Commands
If you suspect your problems are related to a specifi c command, you
can view each command individually and bypass only the command
you think may be causing the problems. To review individual
commands, follow these steps:

Reboot the Allegro by pressing the On/Off key for 8 to 10 seconds
(just until the screen clears). After the system starts, DOS displays
the following message:

Starting

MS-DOS...

While the text is on your screen, quickly press and release the F8
key. One by one DOS displays each command in your CONFIG.
SYS fi le followed by a prompt. To accept a command, press Y for
yes. To bypass a command, press N for No.

When DOS fi nishes processing the CONFIG.SYS fi le, the
following prompt appears:

Process AUTOEXEC.BAT [Y, N]?

If you also want to view the commands in your AUTOEXEC.BAT
fi le, press Y for yes.

1)

2)

3)