Juniper Systems Allegro DOS Manual - Manual (Page 79)

Allegro DOS Owner’s Manual 79
Split Screen
Binary/ASCII (default) shows binary data coming in on the top
section of the screen and ASCII data on the bottom section of the
screen.
Split Screen
Remote/Local shows the data coming in from the remote device on
the top section of the screen and the data going out from the Allegro
to the remote device on the bottom section of the screen.
For example, if you are connected to another computer, characters
you type on the Allegro keyboard appear on the local section of
the screen as well as on the remote computer screen (assuming a
terminal program is being run on the remote computer). Conversely,
If you type characters on the remote computer keyboard, they
appear on the remote section of the Allegro screen.
Single Screen
Remote/Local shows the data coming in from the remote device and
the data going out from the Allegro to the remote device together on
the same screen. The data from the local device is in inverse type.
Saving the Data to a File
If you want to save the data output to the Allegro from another
device to a fi le, press F3 File, and enter a path and fi lename.
Troubleshooting
If you are not seeing what you expect on the screen, make sure the
communication parameters on both devices are set up correctly and
that the device is securely connected to correct port on the Allegro.
▲
▲