Juniper Systems Allegro DOS Manual - Manual (Page 40)

40 Allegro DOS Owner’s Manual
Insert three fresh AA alkaline batteries, taking care to orient them
correctly (only use alkaline batteries). Always replace all three
batteries at once.
Note: For best results, we recommend that you use the new types of alkaline
batteries such as the Duracell Ultra
™ and Energizer Titanium ™ .
Note: Do not use re-chargeable AA battery adapters. The battery life of three
re-chargeable batteries is not cumulative. This means that if a battery equals
1700 milliamp hours (mAh) then three batteries still equals 1700 mAh and
not 5100 mAh.
Slide the door to the alkaline holder back into place, making sure
it snaps securely shut.
The Allegro battery compartment is accessed through a door in
the back of the case. To open the compartment door, push up on
the release latches on the sides of the case. The door pops open.
Remove the NiMH pack or alkaline holder by sliding it to the left
and pulling it out.
Open the door to the alkaline battery holder by pressing in on
both tabs with your index fi nger and thumb as shown.
Place the alkaline battery holder in the left side of the Allegro
battery compartment. Put gentle pressure on the holder while
sliding it all the way to the right.
Press down on the Allegro battery compartment door to close
it. The latches should automatically lock the door into place
and seal the compartment. Make sure that the slide latches are
completely closed.
While you are using the Allegro Field PC, occasionally check
the battery LED indicators above the Allegro display. When the
battery power gets low, replace the alkaline batteries or insert a
NiMH pack.
2)
3)
4)
5)
6)
7)
8)