beautypg.com

For more information, Gps antenna removal – Juniper Systems Allegro DOS Manual User Manual

Page 155

background image

Allegro DOS Owner’s Manual 155

The PC card slot is accessible while the GPS expansion pod is
attached to the Allegro. Refer to Hardware Features, PC Card Slot
in Chapter 2 of this manual, for details on how to use it. There is
a fl at, brown fl ex cable that is part of the expansion pod that is
visible when you open the pod door. Do not twist, bend, or break
this cable while you are using the PC card slot.

If you remove the antenna, place the protective cap over the
antenna connector to keep dirt and moisture out.

For More Information

Your GPS is now confi gured correctly to use the GPS pod. If you
have any questions or still cannot connect, please contact your
reseller or our technical service department at (435) 753-1881, or by
email at [email protected].

GPS Antenna Removal

The GPS antenna can be removed and reattached depending on your
needs. To remove the GPS antenna from your Allegro, complete the
following steps:

Unscrew the antenna cable from the Allegro expansion pod.

Loosen the thumbscrews on the antenna so that the antenna and
the two knobs at the end of the antenna clamp are no longer
securely fastened.

Pull the antenna off of the Allegro.

The antenna can be reattached to the Allegro by following the
instructions in the Attaching the Antenna section found previously
in this chapter.

5)

6)

1)

2)

3)