Juniper Systems Allegro DOS Manual - Manual (Page 23)

Allegro DOS Owner’s Manual 23
Cleaning the Keyboard
Dirt and debris can get underneath the keyboard bezel. To clean it,
use a coin to pull the bezel up at the recess located at the bottom
of the keyboard and remove it. We recommend that you use warm
water, mild detergent, and a toothbrush to clean the keyboard or
simply brush it out. The Allegro remains sealed during this process.
(Do not direct a high pressure stream of water at the keyboard to
clean it. This action could break the seal, causing water to get inside
the Allegro.)
Reattach the bezel by carefully inserting the top ridge under the
function keys and lowering the bezel down fl at onto the case. Press
down along the sides while aligning the keys through the holes.
❖ Important Note: After you reattach the bezel, check each key to make sure
it is completely free from the bezel. If any part of a key is caught underneath
the bezel, you may not be able to turn the Allegro on or you may hear a
continuous string of beeps.
▲