Interlogix Concord 4 REV J Installation Manual - Manual (Page 88)

Chapter 3: Programming
82 Concord 4 Installation Manual
User programming mode
The user programming mode allows you to view system version information and
program system settings. You can enter user programming from an
alphanumeric or fixed display touchpad by using the system or partition master
code. The default system master code is 1234. To enter user programming
mode, press 9, code. The display shows TIME AND DATE. The default settings
are shown in brackets in the table where applicable.
Table 13: User programming menus
Time and date Time
Date
User codes Regular user User 00
Direct bypassing [Off]
Remote access [Off]
System test [Off]
Latchkey report [Off]
Partition assign [1]
Partition master Partition master code [None]
System master System master code [1234]
Options Downloading [On]
Touchpad brightness [2]
Volume [4]
Voice chime [On]
Chime on close [Off]
Set up schedules Schedule 00 to 15
Start time [00:00]
Stop time [00:00]
Monday [Off]
Tuesday [Off]
Wednesday [Off]
Thursday [Off]
Friday [Off]
Saturday [Off]
Sunday [Off]
Attach schedule to
events Latchkey opening Schedule 00 to 15 [Off]
Latchkey closing Schedule 00 to 15 [Off]
Exception opening Schedule 00 to 15 [Off]
Exception closing Schedule 00 to 15 [Off]
Lights 1 to 9 Schedule 00 to 15 [Off]
Output 1 to 6 Schedule 00 to 15 [Off]
Arming Schedule 00 to 15 [Off]