Accessory modules menu – Interlogix Concord 4 REV J Installation Manual User Manual

Page 79

Chapter 3: Programming

Concord 4 Installation Manual

Accessory modules menu

The Accessory modules menu gives you access to the following menus:

Bus devices:

Use these settings to read bus device unit numbers, assign bus

devices to a partition, and configure other features associated with a specific bus
device. (Most bus device settings do not have shortcut numbers).

SnapCards:

Use these settings to set the configuration number for each

SnapCard output, assign SnapCard outputs to a partition, and name the
SnapCard outputs.

Accessory modules - bus device settings

Unit-ID

Shortcut: 10000 to
10015

Default: **** or None

This menu lets you identify all connected bus devices, view each unit
number, view the device ID number, and configure other settings based
on a specific device. This menu also lets you delete learned bus
devices.

To help identify bus devices, the 8-digit device ID number is also located
on a label on each SuperBus 2000 device.

To identify bus device unit and ID:

1. With the display showing

BUS DEVICES

, press #. The display

shows the bus unit number and the 8-digit device ID number. For
example:

UNIT - ID 0—02110185

. Where 0 is the unit number

and 02110185 is the device ID number.

2. Press A

or B

to identify all other bus unit numbers (0 to 15) and

device ID numbers.

To delete learned unit numbers:

1. With the display showing

BUS DEVICES

, press #. The display

shows the bus device set to unit number 0.

2. Press A

or B

until the bus device unit number you want to delete is

displayed.

3. Press D. The display changes the unit number to None.