Roland VS-890 - Manual (Page 9)

Error Messages
Aborted Command!
Illegal Request!
This disk drive cannot be used by the VS-890.
Already Selected
The currently selected disk drive was selected. If you wish to
switch to another disk drive, re-select the disk drive.
Arbitration Failed!
Busy Status!
Check Condition!
Status Error!
Normal communication with the disk drive could not be
accomplished. Make sure that the disk drive is connected
correctly.
Blank Disc
You have tried to run the CD player function using a disc
that has no performance data on it. Insert a commercial CD
or CD-R/RW with material already recorded on it.
Can't Communicate!
Drive Time Out!
Message Error!
Phase Mismatch!
Undefined Sense!
Drive Unknov/n Error!
There is a problem with the connections to the disk drive.
Make sure that the disk drive is connected correctly.
Can't REC CD !
With the factory setting, digital connections cannot be made
with a CD player. Please read 'To Recording Digital Signals"
(User Guide p. 36).
Can't Recover
The drive check Recover procedure could not be executed
because there was insufficient free space on the disk. Delete
unneeded songs. Alternatively, perform the Song Optimize
procedure.
Can't Set Marker
No more than two track number mark points can be set
within a four-second interval.
Complete
The operation ended normally.
Change Int CLK ?
No digital signal is being received at the DIGITAL IN
connector. Select whether or not to switch the sample rate
reference dock to the internal clock. Pressing [ENT/YES]
switches the VS-890 to the internal clock. After checking to
make sure that all digital devices are properly connected and
those sample rates for all devices match, carry out the
operation once more.
Digital in Lock
The sample rate reference dock is set to the digital signal
coming from the DIGPrAL IN connedor. You can record
using the digital connection.
Digital In Unlock
The digital signal is not being input through the DIGITAL IN
connector, or the sample rate set for the song and the sample
rate of the digital device conneded to the DIGITAL IN
connedor are different. In this state, you cannot record using
the digital connedion.
The sample rate spedficd for the song is different than the
sample rate of the digital device connected to the DIGITAL
IN connedor. Press [ENT/YES], and set the sample rates of
both devices to match.
Disk Memory Full!
There is insufficient free area on the disk. Erase unneeded
data. Or, seled a different disk drive. The maximum number
of songs that can be recorded on one partition (200) has been
exceeded. Delete unneeded songs. Or, seled a different disk
drive.
Drive Busy!
If this message appears when you first begin using a disk
drive with the VS-8W, the disk drive is not fast enough.
When using this disk, create a new song with a lower sample
rate or recording mode, and record using this song.
If this message appears after you have been using the disk
drive with the VS-890, the data on the disk drive has become
fragmented, causing delays in reading and writing data.
Either use the track boundng operation to re-record playback
data to another track, or use the optimize operation. If the
same message appears even after these measures have been
taken, copy the song data to another disk drive and initialize
the disk drive that produced the problem.
Event Memory Full!
The VS-890 has used up all the events that can be handled by
one song. Delete unneeded auto mix data. Alternatively,
perform the Song Optimize operation.